Panorama Elevator

1000 lbs. (454 kg) rated load 50 fpm (0.25 m/s) maximum speed 60 ft. (18.29 m) maximum travel 8 stops maximum Automatic controls CSA/UL listed Accordion or scissor style car gates Manual or automatic swing entrances 1:2 cable hydraulic drive Instantaneous safety device Emergency battery lowering & car lights Stainless steel control panel Stainless steel trim Hydraulic pump unit of compact design
SPECIFICATION NOTES EQUIPMENT DATA Landing Entrances (Sliding Doors) Power Unit and Controls Emergency Power Unit Car Enclosure Guide and Brackets 1:2 Hydraulic System -Cylinder and Plunger -Safety Device -Guide Yoke -Hydraulic Valve OPTIONS: Landing Entrances Car Enclosure GENERAL INFORMATION SPECIFICATION NOTES TOP Code Compliance: C.S.A. B 613, ANSI A 17.1 Maximum Car Speed: 30 FPM (0.15 m/s) nominal Maximum Floor Area: 12 sq. ft. ? Automatic Landing and Car Controls Automatic Leveling Maximum Capacity: 750 lbs. (341 kg) Maximum Travel: 50 ft. (15 m) EQUIPMENT DATA TOP Landing Entrances (Slidng Doors): TOP Each landing entrance is supplied as an integral door/frame assembly and labeled to certify that it has been laboratory tested and listed for a minimum fire separation rating of 1-1/2 hours. Standard hardware included is as follows: Flush design door panels, sight guards. Extruded aluminum sills, strut angles. Headers, hanger covers. Finish: Prime coat ready to be painted by others. Power Unit and Controls: TOP The controller is integrally mounted with the hydraulic power unit and is wired and tested prior to leaving the factory. The salient features of the power unit are as follows: A hydraulic pump unit is supplied for quite smooth operation. The pump is connected through a flexible coupling to a continuous rated motor of a voltage as required by the individual project. (208V, 3 phase or 220/230V, single phase). The pump and motor are individually sized to provide the required oil flow and pressure to the cylinder. A relief valve, capable of full bore release is supplied to relieve any pressure which may build up in excess of 24% of the maximum allowable. This valve is tested on site, tagged and sealed by an inspector of the local enforcing authority. Note: Inspections are not always required for residential elevators. Please check with your local dealer representative. A check valve with a cracking pressure of approximately 5 psi is supplied in the pressure line. This valve automatically opens on start up of the pump and allows full flow of oil to the cylinder. The valve prevents any oil leakage in the cylinder to reservoir direction and is capable of fully supporting the car and it`s rated load on a locked column of oil. An adjustable flow control device is incorporated in the solenoid down valve to regulate the car down speed in the down direction. The solenoid down valve opens to allow the return of oil to the reservoir when the down button is operated. A manual lowering valve is included to bypass the solenoid down valve in the event of a main building power failure. The oil reservoir is supplied with a tank breather with integral filter and filler cap. An oil level gauge is mounted on the front of the tank to visually show oil levels as well as oil temperature. The suction line is supplied with a filter to prevent dire particles from entering the pump. Minimum recommended pump room size is 3' x 3'. Option: "Super-Hush" submersible pump unit. Option: Pump unit steel enclosure cabinet. Emergency Power Unit: TOP An emergency lowering power supply to allow the lift to operate in the down direction should the normal building power supply fail. Car Enclosure: TOP standard platform size: 36" x 48" (914mm) x (1219mm) with enclosed sides of at least 80" (2032mm) high wall panels are ½" thick, finished to meet the architect's specifications car control station with emergency stop button and alarm solid ceiling with two stainless steel pot lights emergency light and alarm activation in the event of a main building power failure key switch arrangement through control circuitry to shut the elevator off at either the landings or from the car car platform is constructed of formed steel with 5/8" plywood sub-flooring to be finished by others all car components including panels are bolted together for easy repair and removal platform edge on the car side is equipped with an apron extending below the platform floor at least 6" with 2" 30 degree band at the lower edge Option: Plastic laminate panels Guide and Brackets: TOP The car guides used are planed, elevator "T" rails, 8#/ft in weight and spliced with machined surface fishplates.Guide rail brackets are bolted through the hoistway enclosure with back-up plates, washers and nuts.Approved elevator guide shoes (minimum of 4 nylon with steel inserts) are used. 1:2 Hydraulic System: TOP Eliminates the need to drill cylinder hole. Reduces overhead clearances. Cylinder and Plunger TOP The cylinder shall be contructed of steel pipe of sufficient thickness and suitable safety margin. The top of the cylinder shall be equiped with a cylinder head with an internal guide ring and self adjusting packing. The plunger shall be constructed of a steel shaft of proper diameter machined true and smooth. The plunger shall be provided with a stop electrically welded to the bottom to prevent the plunger from leaving the cylinder. Cable Minimum two 3/8" Safety Device TOP A "slack/broken cable" safety device shall be supplied which will stop ans sustain the elevator and its rated load, if either of the hoisting cables become slack or breaks. The safety device shall be resettable by the operation of the elevator in the upward direction. A switch shall be mounted in such a position to sense the operation of the safety device, and will open the safety circuit to the controller to prevent operation of the elevator in either direction. Guide Yoke TOP The 1:2 guide yoke/sheave arrangement shall be supplied with a sheave, guide shoes, roller bearings and adjustable cable guards. The sheave shall be finished with rounded grooves to fit the cables supplied. Hydraulic Valve TOP In addition to the standard operating features of the hydraulic control valve, there shall be a pressure sensitive check valve which will activate when negative pressure is sensed in the hydraulic system. The check valve will close and stop the hydraulic jack from descending immediately on sensing of negative pressure. OPTIONS TOP Landing Entrances TOP Stainless steel, brass or specified cladding. Baked enamel or air dried urethane finish to selected colour. Automatic door openers. Car Enclosure TOP Telephone cabinet. Various interior cab panel fininshes. Brass package consisting of a brass car station plate, brass pot lights, brass trim. Custom car enclosure to suit any specification. Photoelectric eyes. Braille plates. Arrival gongs and lights Digital floor indicator lights. Car gates: manual or powered accordion folding, manual black scissor, bi-folding. Rubber or carpet flooring. Motion activated cab lights. Voice activated controls. Voice announciators. Electronic keyless access control. Optional platform configurations such as 90 degree, side opening, as well as three sided openings (see Sample Drawings). GENERAL INFORMATION TOP Standard capacity: 750 lbs (341 kg). The car speed is approximately 30 fpm in both directions while carrying rated load. Shop drawings are prepared by Federal Elevator, using good drafting procedures, and are submitted to the architct and/or customer for approval prior to installation. License fees are the responsibility of the owner. The lift contractor will provide three (3) months free service and maintenance from date of approval by inspectors. The entire lift and all component parts carry a one (1) year guarantee. The guarantee is for the replacement at no cost of defective parts but does not include the labour costs required to replace the defective part(s). For details on 5 year limited warranty, contact Federal Elevator or the area official dealer.
Drawings Installation And Owners Manual Owners Manual

>> Federal Elevator Main Menu..! <<

Main Elevator Menu   -   Wheelchair Lift Main Menu!

Planet Mobility Main Directory!

 
Planet Mobility Main Menu.!  -  Online Mall